Installation

  • Protector is mainly mounted easily in partial flow (BYPASS) over an already existing pump in the system. (Can be mounted in “full flow” if desired)
  • Water meter and control valve are mounted on outlet.
  • Used to set circulating water limit after installation. (See manual)
  • Ball valve is mounted on inlet / outlet for closing unit during service etc.

Protector is delivered with two inlets on the top of the tank and two outlets a bit lower.

The one inlet/ outlet not in used are to be plugged (1” female plug)

It is important that the top lid is mounted in the same direction, remember that the arrow is set in the same direction as where the inlet is.